Darien, CT · Open 7 AM to 10 PMCall: (475) 271-1543

Garage Door Spring Repair

Broken spring? Leave the door down — across Darien, Rowayton, New Canaan, Norwalk, Stamford, Westport, Wilton, Greenwich.

When a garage door spring breaks, the door loses the one part that carries its weight, and the safe response is to leave the door closed and call. Depending on its size and insulation, a door can weigh about 90 pounds or well over 500, and the spring is what lifts nearly all of it. Once a spring lets go, the opener, the cables and anybody's hands are left holding that load, which is how openers strip their gears and doors come down hard.

We size springs from the door in front of us and not from a chart: its weight, the wire size, the length and the inside diameter, with insulation, glass and added trim counted in. If the door has two springs, both come out together, which is also DASMA's advice, because they have worked equally hard. Then we wind to the correct number of turns, check how the cables seat in the drums, and prove the balance by leaving the door resting partway open.

Clues a Spring Has Broken or Is Close

  • Something snapped overhead, and now the door refuses to lift
  • A visible gap in the coil of a spring above the door
  • The opener runs but the door barely moves, or drops back
  • The door is hard to lift by hand and feels twice as heavy
  • The cables hang slack, or one side sits crooked
  • Rust-brown pitting or flaking on the spring coils

🌊 The Long Island Sound Factor

Springs fail earlier near salt water. DASMA's guidance on spring cycle life explains that rust pits the wire, that fatigue cracks grow out of those pits and cut the spring's life, and that regular lubrication to the door maker's instructions helps a spring last. It also advises keeping doors closed near a saline coast. A spring is bare steel by design, so on shoreline addresses we fit coated springs and oil them as the maker specifies, and on any older spring we look hard at the coils for pitting before we leave it in service.

How We Handle It

Step 1

Weigh and measure

Door weight, wire size, length and inside diameter are measured, so the spring set matches this door and not a chart average.

Step 2

One quote, approved first

The springs, the labor and any extras are quoted as a single number on site, and nothing is unwound until you approve it.

Step 3

Replace the set

Winding bars, the correct number of turns, fresh cable seating and, on a two-spring door, both springs replaced together.

Step 4

Balance and cycle test

The door has to stay where it is left a few feet off the floor. Then the opener runs full cycles and the reversal test is repeated.

Starting Prices: Garage Door Spring Repair

Garage Door Spring Replacement
From $150 per spring
Diagnostic Service Call
$0 with a completed repair

Starting prices for Fairfield County jobs. The door's size and weight, the parts it needs and how many of them change set the final figure, and you approve that number on site before any work begins.

Technician on a ladder reaching the top section of a white garage door
Technician on a stepladder working on a garage door with a row of windows

Related: all garage door services · contact the Darien office · common questions

Garage Door Spring Repair — FAQs

One spring broke. Should the other be changed too?
Yes, whenever the door has two. DASMA recommends changing both together, whichever one snapped, because they carry equal loads and share the same age and cycle count, so the survivor is usually near the end of its life. It also keeps the door evenly balanced.
How many cycles does a typical spring give?
A garage door spring lasts a set number of open-and-close cycles, not a set number of years, so a busy household uses one up sooner. DASMA notes that spring life and door life are different measures. A spring built for more cycles lasts longer on a door used many times a day.
Is it safe to lift the door by hand with a broken spring?
No. Without the spring, nothing offsets the door's weight, and a hand lift can strain your back or let the door fall. DASMA says not to run a door with a broken spring until the spring is replaced. If a car is trapped, call, and we will tell you what is safe to do.
Why not change a torsion spring yourself?
Not safely. Torsion springs hold stored energy and a slipped winding bar causes injuries. DASMA states that springs should be replaced only by a trained door systems technician, and that spring color codes identify only part of what a replacement needs.
Why did my new spring break after only a few years?
Heavy use, rust and a spring that was wrong for the door are the usual causes. DASMA lists rust pitting, a spring applied to the wrong door and the wrong number of turns as common ways to shorten a spring's cycle life, which is why we size from the actual door.
Where We Provide Garage Door Spring Repair

Garage Door Spring Repair Across Fairfield County

Contact Us

Reach Sound of Kings in Darien

Describe what the door is doing, from a bang overhead to a remote that quit, and someone from the Old Kings Highway office phones you back. Every service page shows where its price starts, and the exact figure for your door is agreed on site before a tool comes out.

Sound Garage Door Repair Expert of Kings
19 Old Kings Hwy S Ste 200
Darien, CT 06820

Phone: (475) 271-1543
Email: info@soundgaragedoorrepairkings.com
Hours: open 7 AM to 10 PM, 7 days a week

Get My Free Estimate ☎ Call (475) 271-1543

How we handle what you send us: privacy policy.

☎